Skip to content
Serving Reseda and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (213) 401-2183

Heating Repair in Simi Valley, CA

Serving Simi Valley and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (213) 401-2183

The short answer

Ventora HVAC Repair Service fixes gas furnaces, heat pumps and thermostats in Simi Valley homes in ZIP codes 93063 and 93065. We trace the problem step by step and explain what failed and what the repair involves. If replacement comes up, we confirm the rules and rebates that apply to your address.

When the first cold nights settle into Simi Valley, many furnaces get switched on for the first time in months, and that's when problems show up. Ventora HVAC Repair Service handles heating repair for homes across Simi Valley, in ZIP codes 93063 and 93065, from our base in Reseda about 14 miles east. We repair gas furnaces, heat pumps, and the thermostats and ductwork that connect them. Before any work starts, we explain in plain terms what we found.

Why Heaters Fail in Simi Valley Homes

Simi Valley sits inland, so summers run hot and dry while winters stay mild by most standards. Mild doesn't mean warm, though. Winter nights in the valley can get cold enough that a home without working heat becomes uncomfortable fast, especially for kids, older relatives and pets.

The bigger issue is how little most heaters run here. A furnace can sit idle from spring through fall while the air conditioner does all the work. During those months, dust settles on burners and sensors and filters load up from summer use. Parts that were already wearing out stay hidden. A weak ignitor or dirty flame sensor often gives out during the first cold snap of the season.

Fall Santa Ana winds add another factor. Those hot, dry, gusty spells push fine dust into attics, garages and return vents, which is where many furnaces and air handlers are installed.

What Happens on a Heating Repair Visit

We start by asking what you've noticed. That might be no heat at all, heat that cuts out, strange smells, new noises, or a system that runs but never warms the house. Then we work through the system in order instead of guessing at parts. A typical visit covers:

Once we find the cause, we tell you what failed, why it failed, and what the repair involves. If another part looks close to failing, we point it out so you can decide whether to deal with it now or later.

  • Thermostat settings, wiring and power, including batteries and the furnace service switch
  • Air filter condition and airflow at the return and supply registers
  • Ignition sequence: inducer motor, pressure switch, ignitor and flame sensor
  • Burner flame, a visual check of the heat exchanger, and venting
  • Blower motor, capacitor and blower wheel condition
  • Limit switches and any error codes from the control board
  • Condensate drain on high-efficiency furnaces

Furnace and Heat Pump Problems We Fix

Most heating calls in Simi Valley involve gas furnaces. More homes are adding heat pumps, though, and heat pumps fail in different ways. Common repairs include:

A light burning smell for a few minutes on the first run of the season is usually dust burning off. If the smell lingers, or if it smells like rotten eggs or burning wires, shut the system off. If you smell gas, leave the house and call your gas utility or 911 from outside. If a carbon monoxide alarm sounds, get everyone outdoors and call 911.

  • A furnace that clicks, tries to light, then shuts off, often because of a dirty flame sensor or failing ignitor
  • Short cycling caused by a clogged filter tripping the high-limit switch
  • A blower that won't start, hums, or runs nonstop
  • A heat pump that blows cool air in heating mode, ices over, or gets stuck in defrost
  • Uneven heat between rooms from disconnected or crushed attic ducts
  • A thermostat that doesn't call for heat or keeps losing its settings

Repair or Replace? What to Know First

Most heating problems can be repaired, and we'll tell you when that's the case. Replacement may make more sense when a furnace has a cracked heat exchanger, keeps having major failures, or needs parts that are hard to find. In that situation, we lay out both options so you can compare them.

If you're weighing a new furnace, regulations matter. In the Los Angeles region, South Coast AQMD Rule 1111 limits NOx emissions from new gas furnaces, and the district has been amending the rule toward zero-emission requirements. Simi Valley is in Ventura County. Before recommending equipment, we check which air-quality rules apply at your address and what the current compliance dates are.

Rebates depend on which utility serves your home. LADWP's heat pump rebates are only for LADWP customers, and many homes outside the City of Los Angeles are served by Southern California Edison instead. We confirm the current offer for your address before quoting it. The federal 25C tax credit only covered heat pumps placed in service before December 31, 2025, so it doesn't apply to new installations.

Serving Simi Valley and Nearby Communities

We serve homes throughout Simi Valley in 93063 and 93065. We also serve Agoura Hills, Hidden Hills, Calabasas, Santa Clarita and San Fernando. If your heater has quit or isn't keeping up, contact us to schedule a visit. Tell us what type of system you have, what it's doing, and when the problem started, and we'll come prepared.

More services in Simi Valley

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and track down what is actually wrong before suggesting parts or replacements, so you know what you are paying to fix.

  2. Explain your options

    We tell you what we found, what each option involves, and when a repair is reasonable versus when replacement deserves a closer look. The decision is yours.

  3. Check local rules and rebates

    Furnace rules and utility rebates in the Los Angeles area change and depend on your address. We confirm what currently applies to your home before we bring it up.

FAQ

Common questions

Why does my furnace smell like burning the first time I turn it on?

Dust settles on the burners and heat exchanger during the months the furnace sits unused, and it burns off on the first run. The smell should fade within a few minutes. If it doesn't, or if it smells like gas or burning wires, turn the system off and call for service.

My furnace lights and then shuts off after a few seconds. What's wrong?

A dirty or failing flame sensor is a common cause. The furnace lights, can't confirm the flame, and shuts down for safety. A weak ignitor, a venting problem or a pressure switch issue can cause similar behavior, so we test each one instead of guessing.

Do you repair heat pumps as well as gas furnaces?

Yes. We repair heat pumps that blow cool air in heating mode, ice over, get stuck in defrost, or won't switch between heating and cooling. We also work on the thermostats and ductwork connected to both kinds of systems.

Can I get an LADWP rebate on a heat pump in Simi Valley?

LADWP rebates are only for LADWP electric customers. Simi Valley is outside the City of Los Angeles, and many homes outside the city are served by Southern California Edison instead. We check which utility serves your address and confirm the current offer before quoting it.

Is the federal tax credit for heat pumps still available?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date.

What should I check before calling for heating repair?

Make sure the thermostat is set to heat and has working batteries. Check that the furnace service switch is on and the breaker hasn't tripped. Replace the air filter if it's dirty. If the heat still doesn't work, schedule a repair visit.

Tell Us What Your System Is Doing

Whether your AC is blowing warm air, your furnace won't start, or you are thinking about a heat pump, reach out to Ventora HVAC Repair Service. We will diagnose the problem and walk you through your options.

Call (213) 401-2183 Request Service