Skip to content
Serving Reseda and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (213) 401-2183

Furnace Repair in Santa Monica, CA

Serving Santa Monica and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (213) 401-2183

The short answer

Most furnace problems in Santa Monica come from systems that sit idle for months, such as dirty flame sensors, weak igniters, clogged filters and tripped safety switches. Ventora diagnoses the fault, explains your repair options, and tells you plainly whether the furnace is worth repairing or close to replacement.

Santa Monica winters are mild, so most furnaces here sit unused for much of the year and then get switched on during the first cold nights. That pattern causes its own problems. Dust settles on burners, igniters weaken without anyone noticing, and a filter left in since last winter can choke airflow on day one. Ventora HVAC Repair Service travels from our base in Reseda, about 12 miles away, to repair gas and electric furnaces in homes, condos and apartments across ZIP codes 90401, 90402, 90403, 90404 and 90405. Our goal is to find the real cause, explain it in plain terms, and fix what needs fixing.

Why Furnaces Act Up in a Coastal Climate

Los Angeles has a Mediterranean climate with dry summers and mild winters, and coastal areas like Santa Monica stay cooler in summer and milder in winter than the inland valleys. A furnace here may run only a few weeks a year. Parts that sit still for long stretches tend to fail at startup, which is why many repair calls come in during the first chilly evenings of the season.

Moist marine air can also take a toll on metal parts in garages, closets and attics over time. When we inspect a furnace, we look for rust on burners, heat exchanger surfaces, flue connections and electrical terminals, because corrosion can cause poor ignition or venting problems.

Common Furnace Problems We Repair

Many Santa Monica homes have compact systems tucked into hall closets, attics or garages, and older properties may still have wall or floor furnaces. We work on the usual setups and on the tight spaces that come with them. These are the problems we see most often:

  • Furnace clicks or tries to light, then shuts off, often caused by a dirty flame sensor
  • No heat at all because of a failed hot surface igniter or pilot assembly
  • Blower runs but the air coming out is cool or lukewarm
  • Short cycling, where the furnace turns on and off every few minutes
  • Burning dust smell that doesn't fade after the first hour of use
  • Rattling, squealing or booming sounds at startup
  • Tripped limit switch or pressure switch from restricted airflow or a blocked vent
  • Thermostat that doesn't call for heat or reads the room wrong

How a Repair Visit Works

We start by asking what you've noticed: when the problem began, what sounds or smells came with it, and whether any error lights are blinking on the control board. Then we check the thermostat, filter, gas supply or electrical power, ignition sequence, burners, blower, safety switches and venting.

Once we find the cause, we explain what failed and why, along with your options. Many repairs, like cleaning a flame sensor or replacing an igniter, can be handled in a single visit. If a part needs to be ordered, we tell you up front. Safety comes first: if we find signs of a cracked heat exchanger or a venting problem that could let combustion gases into the home, we'll tell you directly and explain the next step.

Repair or Replace? What Santa Monica Homeowners Should Know

We don't push replacement when a repair makes sense. But if your furnace is old, needs repeated repairs, or has a serious safety issue, it helps to understand the rules before you choose new equipment. South Coast AQMD Rule 1111 limits NOx emissions from natural-gas fan-type central furnaces sold and installed in the Los Angeles region, and the district has been amending it toward zero-emission requirements. Because the district sets and revises the compliance dates, anyone planning a furnace replacement should check the current rule first.

Some homeowners look at a heat pump instead, since it handles both heating and cooling. Rebates depend on which utility serves your address. Many homes outside the City of Los Angeles, including much of the Westside, are served by Southern California Edison rather than LADWP, so we confirm the current offer for your address before quoting it. Also note that the federal 25C tax credit for heat pumps ended for equipment placed in service after December 31, 2025, so it no longer applies to new installations.

Simple Checks Before You Call

A few quick checks can save you a visit. Make sure the thermostat is set to heat and the setpoint is above room temperature. Replace the batteries if the screen is blank. Check that the furnace power switch, which often looks like a light switch near the unit, is on, and that the breaker hasn't tripped. Look at the filter, since a clogged one is a common cause of shutdowns. If you smell gas, leave the home and contact your gas utility right away before calling anyone else.

More services in Santa Monica

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and track down what is actually wrong before suggesting parts or replacements, so you know what you are paying to fix.

  2. Explain your options

    We tell you what we found, what each option involves, and when a repair is reasonable versus when replacement deserves a closer look. The decision is yours.

  3. Check local rules and rebates

    Furnace rules and utility rebates in the Los Angeles area change and depend on your address. We confirm what currently applies to your home before we bring it up.

FAQ

Common questions

Why does my furnace smell like burning when I first turn it on?

After months of sitting idle, dust collects on the burners and heat exchanger and burns off when the furnace starts. A light smell that fades within an hour or so is normal. If it lingers, smells electrical, or comes with smoke, turn the furnace off and schedule a repair.

My furnace lights for a few seconds and then shuts off. What's wrong?

This is often a dirty or worn flame sensor that can't confirm the burner has lit, so the furnace shuts the gas off as a safety step. It can also point to a venting or pressure switch issue. A technician can test each part and find which one is causing the shutdown.

Do you repair wall furnaces and floor furnaces?

Yes. Many older homes and apartments in Santa Monica use wall or floor furnaces instead of central forced-air systems. We repair these units and can tell you whether a repair is reasonable or whether the unit is near the end of its useful life.

Which Santa Monica ZIP codes do you serve?

We serve homes in 90401, 90402, 90403, 90404 and 90405. We also work in nearby Los Angeles, Culver City, Beverly Hills, West Hollywood and Calabasas.

Can I get a rebate if I replace my furnace with a heat pump?

It depends on your utility. LADWP offers heat pump rebates to its residential electric customers, but many homes outside the City of Los Angeles are served by Southern California Edison instead. We confirm which offers apply to your address before quoting any rebate.

Is the federal heat pump tax credit still available?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date.

Tell Us What Your System Is Doing

Whether your AC is blowing warm air, your furnace won't start, or you are thinking about a heat pump, reach out to Ventora HVAC Repair Service. We will diagnose the problem and walk you through your options.

Call (213) 401-2183 Request Service