Skip to content
Serving Reseda and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (213) 401-2183

Heat Pump Installation in Burbank, CA

Serving Burbank and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (213) 401-2183

The short answer

A heat pump is a strong fit for most Burbank homes because it handles hot inland summers and mild winters with one electric system. Ventora sizes each system to the house, checks ducts and electrical capacity, and confirms which utility rebates apply to your address before quoting.

Ventora HVAC Repair Service installs heat pump systems for homeowners throughout Burbank, including ZIP codes 91501, 91502, 91504, 91505 and 91506. Burbank is about 11 miles east of our base in Reseda, so it's a short, familiar drive for our installers. A heat pump cools and heats your home with one electric system. It works well in an inland city with hot summers and mild winters. This page covers how we plan and install a heat pump in a Burbank home, whether you're replacing an aging air conditioner, a gas furnace or both. It also covers the rules and rebate questions that come up for addresses here.

Why Heat Pumps Suit Burbank's Climate

Los Angeles has a Mediterranean climate with dry summers and mild winters. Inland neighborhoods and valleys run much hotter in summer than areas near the coast. Fall Santa Ana winds can also bring hot, dry spells after summer seems to be over. For a Burbank home, cooling is usually the bigger and longer job of the year, so we size a heat pump around that summer load first.

Mild winters are where heat pumps do their best work. On a cool evening, the system pulls heat from the outdoor air and moves it inside instead of burning fuel. In most Burbank homes, a properly sized heat pump covers the whole heating season without a separate furnace. You also get one system to maintain instead of two.

What a Heat Pump Installation Involves

Every installation starts with a visit to your home. We don't size a new system by copying the label on the old one. Older equipment was often oversized or undersized, and homes change over time with additions, new windows or added insulation. Here's what we check and handle:

  • A room-by-room load calculation so the system matches your home's actual cooling and heating needs
  • An inspection of existing ductwork for leaks, crushed or disconnected runs, and undersized returns
  • A review of your electrical panel to confirm capacity and a suitable circuit for the outdoor unit
  • Placement of the outdoor unit with enough clearance for airflow, service access and reasonable noise near bedrooms or neighbors
  • Removal of old equipment, with refrigerant recovered properly
  • Startup testing of airflow, refrigerant charge and thermostat settings, followed by a walkthrough of how to run the system

Ducted or Ductless: Matching the System to Your House

If your home already has ducts in good shape, a ducted heat pump can often connect to the existing system. That keeps the change mostly at the equipment level. If the ducts are leaky or poorly laid out, we'll show you what we found and explain what repair would involve before you decide.

Some homes don't have ducts at all. Others have a converted garage, an addition or a back bedroom the central system never reached well. A ductless mini-split heat pump can serve those spaces with individual indoor units. We'll lay out the trade-offs of each approach for your specific floor plan.

Replacing a Gas Furnace in Burbank

Many Burbank homes still heat with a natural-gas forced-air furnace. South Coast AQMD Rule 1111 limits NOx emissions from natural-gas fan-type central furnaces sold and installed in the Los Angeles region. The district has been amending the rule toward zero-emission requirements and sets and revises the compliance dates itself. If you're planning to replace a furnace, check the current rule before choosing equipment.

Switching to a heat pump is one way to plan around that change, since it heats without burning gas. During your estimate, we'll go over what the current rule means for your replacement so you can make the decision with the full picture.

Rebates and Tax Credits for a Burbank Address

Burbank is outside the City of Los Angeles, and that matters for rebates. LADWP residential electric customers can apply for Consumer Rebate Program rebates on qualifying heat pump systems. The amount is based on the unit's SEER2/HSPF2 rating. The application is filed after the equipment is purchased and installed, within 12 months of purchase. Many homes outside the city are served by a different utility, though, and available rebates depend on the utility that serves your address. We confirm the current offer for your home before we quote it.

On the federal side, the Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date, so we won't factor it into your planning.

Serving Burbank and Nearby Communities

We install heat pumps across Burbank and in nearby areas, including West Hollywood, Beverly Hills, San Fernando, Los Angeles and Culver City. Wherever you live in this area, the process is the same: an in-home assessment, a clear explanation of your options, and a careful installation tested before we leave.

More services in Burbank

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and track down what is actually wrong before suggesting parts or replacements, so you know what you are paying to fix.

  2. Explain your options

    We tell you what we found, what each option involves, and when a repair is reasonable versus when replacement deserves a closer look. The decision is yours.

  3. Check local rules and rebates

    Furnace rules and utility rebates in the Los Angeles area change and depend on your address. We confirm what currently applies to your home before we bring it up.

FAQ

Common questions

Will a heat pump keep my Burbank home cool during a summer heat wave?

Yes, if it's sized correctly. Inland areas run much hotter than the coast, so we size the system around your home's summer cooling load using a room-by-room calculation.

Can a heat pump replace both my air conditioner and my gas furnace?

In most Burbank homes, yes. Winters here are mild, so one heat pump can usually handle both cooling and heating without a separate furnace.

Can I get the LADWP heat pump rebate in Burbank?

It depends on the utility that serves your address. Burbank is outside the City of Los Angeles, and many homes outside the city aren't LADWP customers. We confirm the current rebate offer for your address before quoting it.

Is the federal heat pump tax credit still available?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It doesn't apply to new installations after that date.

Do I need ducts for a heat pump?

No. Homes with good ductwork can use a ducted heat pump. Homes without ducts, or rooms the current system doesn't reach, can use a ductless mini-split.

Does Rule 1111 affect my furnace replacement?

It may. South Coast AQMD Rule 1111 limits NOx emissions from gas fan-type central furnaces in the region and is being amended toward zero-emission requirements. Check the current rule before you replace a gas furnace.

Tell Us What Your System Is Doing

Whether your AC is blowing warm air, your furnace won't start, or you are thinking about a heat pump, reach out to Ventora HVAC Repair Service. We will diagnose the problem and walk you through your options.

Call (213) 401-2183 Request Service